How to draw the separated flat slab?

[ammer]

dear all members
i would like to show me to how i draw the flat slab edge or separated flat slabs so can i check the deflection and the reinforcement on the cantilever
plz check my attches
thanks

 

[Hakan Şahin]

dear all members
i would like to show me to how i draw the flat slab edge or separated flat slabs so can i check the deflection and the reinforcement on the cantilever
plz check my attches
thanks

Hi Ammer,
There are no defined slabs in your project. Please define your slabs in your project and mark your questions on it or add some pictures that we can answer your question precisely.

 

[Hakan Şahin]

I figured you asked this, see the following link:

Bu linki görmek için izniniz yok. Giriş yap veya üye ol.

see the file I enclosed. If you have any question, feel free to ask.

 

[ammer]

hello mr. hakan
i want you to draw the separated flat slab for this model not by one part
or my query is to assigning the edge slab line from center of columns or not?
thanks again

 

[Hakan Şahin]

hello mr. hakan
i want you to draw the separated flat slab for this model not by one part
or my query is to assigning the edge slab line from center of columns or not?
thanks again

see the project I added above then.

 

[ammer]

many thanks mr hakan
one more question
in the reports,where can i find the slab punching check?
thanks

 

[Hakan Şahin]

in the reports,where can i find the slab punching check?
thanks

Hi Ammer

There are some beams on story in your project beside beamless columns. In this case, in order to see punching check for beamless column, you need to define column supports for per beamless column.

After analysis, you will see punching checks on slab report

 

[ammer]

dear hakan
do you mean that i assign a zero depth for the panel as a clip below ?!!!

 

[Hakan Şahin]

dear hakan
do you mean that i assign a zero depth for the panel as a clip below ?!!!

No need. Only zero "height" will be enough.

 

[ammer]

MANY THANKS DEAR HAKAN
SO, AS I UNDERSTAND YOU,I WILL ASSIGNING THE CAPITAL COLUMN ONLY FOR PUNCHING CHECK AND AFTER THAT ,WE SHOULD DELETE THEM ?!!!!

 

[Hakan Şahin]

MANY THANKS DEAR HAKAN
SO, AS I UNDERSTAND YOU,I WILL ASSIGNING THE CAPITAL COLUMN ONLY FOR PUNCHING CHECK AND AFTER THAT ,WE SHOULD DELETE THEM ?!!!!

you may delete them but if you do so, you dont see slab punching checks on report. You may leave them. they effect nothing on your project but punching checks

 

[ammer]

MANY THANKS

 

[ammer]

Re: How to fix this issue ???

dear hakan
while i'm modelling the flat slab and assigning the concrete directions,i got this error
please need your tips....
down load the model from her:

Bu linki görmek için izniniz yok. Giriş yap veya üye ol.

 

[Hakan Şahin]

Hi Ammer
See the explanation on enclosed picture: